Laserfiche WebLink
Installation Instructions FTR1U / FTR100 <br />5 <br />INSTALLATION <br />The FTR1U/FTR100 may be installed either centered on a <br />single wood stud, or anchored to a single wood stud on one <br />side, and to drywall (1/2” minimum thickness) on the other side. <br />The FTR1U/FTR100 allows a tilt range from +5° to -15°. <br />Install Mount Centered to Single Wood Stud <br />1. Determine approximate mounting location, keeping in mind <br />the display size. <br />2. Use a stud sensor to locate applicable wood stud. Mark <br />location with a pencil. <br />3. Level FTR1U/FTR100 assembly (A) at desired height and, <br />using it as a template, mark the location of upper and lower <br />pilot holes. Ensure marks are in the center of wood stud. <br />NOTE:Mount can provide ±1/2” of lateral shift by using mount <br />holes on either side of vertical center line. <br />WARNING:ELECTRICAL SHOCK HAZARD! Drilling into <br />electrical wires or cables can cause DEATH or SERIOUS <br />PERSONAL INJURY! ALWAYS make certain area behind <br />mounting surfaces is free of electrical wires and cables <br />before drilling or installing mount fasteners. <br />4. Drill pilot holes using a 1/8” drill bit. Ensure pilot holes are <br />straight. <br />5. Fasten FTR1U/FTR100 assembly to wood stud using two <br />#10 x 2-1/2” Phillips head screws (B) through two #10 <br />washers (C),FTR1U/FTR100 assembly (A), and drywall (not <br />shown) and install into pilot holes. (See Figure 1) <br />Figure 1 <br />Install Mount to a Single Wood Stud and Drywall <br />WARNING:Drywall must have a minimum thickness of 1/2” <br />and a maximum thickness of 5/8”. Do not install drywall <br />anchors into the seam between drywall pieces. <br />1. Determine approximate mounting location, keeping in mind <br />the display size. <br />2. Level FTR1U/FTR100 assembly (A) at desired height and, <br />using it as a template, mark the location of the four anchor <br />holes (one in each corner slot). (See Figure 2) <br />IMPORTANT ! :Two holes MUST be centered on a <br />single wood stud. <br />WARNING:ELECTRICAL SHOCK HAZARD! Drilling into <br />electrical wires or cables can cause DEATH or SERIOUS <br />PERSONAL INJURY! ALWAYS make certain area behind <br />mounting surfaces is free of electrical wires and cables <br />before drilling or installing mount fasteners. <br />3. Drill 1/8” pilot holes in wood stud locations. Ensure pilot <br />holes are straight. (See Figure 2) <br />4. Drill 3/8” anchor holes in the other two marked locations. <br />Ensure holes are straight and completely through drywall. <br />(See Figure 2) <br />Figure 2 <br />2 <br />4 <br />x 2 <br />x 2 <br />5 (B) x 2 <br />(A)(C) <br />3 x 2 <br />4 x 2 <br />x 42 <br />1/8” <br />3/8”