Laserfiche WebLink
Installation Instructions FTR1U / FTR100 <br />7 <br />2. Lift and maneuver display such that all mounting buttons fit <br />into openings on FTR1U/FTR100 assembly (A). (See <br />Figure 7) <br />3. Lower display firmly into place. Ensure each mounting <br />button has fully seated in the opening. (See Figure 7) <br />4. Close latching flag by rotating flag counterclockwise on <br />FTR1U/FTR100 assembly (A). (See Figure 7) <br />Figure 7 <br />NOTE:Example shows mounting display in the 100mm x <br />100mm pattern. FTR1U/FTR100 assembly (A) will also <br />accommodate a 75mm x 75mm pattern. (See Figure 8) <br />Figure 8 <br />NOTE:An optional padlock may be used to secure latching flag <br />in place. (See Figure 9) <br />Figure 9 <br />5. Connect cables to display as required. <br />Adjusting Tilt <br />1. Loosen adjusting screws on each side of display (See <br />Figure 10). <br />2. Adjust tilt as desired. <br />3. Tighten adjusting screws. <br />Figure 10 <br />2 <br />3 <br />Display <br />(A)4 <br />Latching flag <br />Button location for <br />100mm x 100mm <br />pattern (4 places) <br />Button location for <br />75mm x 75mm <br />pattern (4 places) <br />NOTE: Display not shown for clarity. <br />NOTE: Display not shown for clarity. <br />Add padlock here <br />5° Tilt Up 15° Tilt Down <br />1 2 3