Laserfiche WebLink
PDR Series Installation Instructions <br />6 <br />MOUNT INSTALLATION <br />Installing Mount to Wall <br />WARNING:IMPROPER INSTALLATION CAN LEAD TO <br />MOUNT FALLING CAUSING SERIOUS PERSONAL <br />INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s <br />responsibility to make sure the structure to which the mount <br />is being installed is capable of supporting five times the <br />combined weight of the mount and all attachments. <br />1. Determine mounting location taking into consideration <br />display size and PDR’s range of movement. <br />2. Using a stud sensor locate two wood studs 16” apart on <br />center. (See Figure 1) <br />Figure 1 <br />3. Place and level mount against wall, aligning mounting holes <br />in upper and lower wall channels with studs. (See Figure 1) <br />4. Mark four mounting holes making sure mounting holes are <br />located as close as possible to center of studs. (See Figure 1) <br />5. Drill four 7/32" pilot holes where the mounting holes were <br />marked. (See Figure 1) <br />6. Partially install two 5/16" x 3-1/2" lag bolts (H) into upper <br />pilot holes. DO NOT tighten at this time. (See Figure 2) <br />7. Align mounting holes in upper wall channel with lag bolts, <br />and hang mount on lag bolts. <br />8. Adjust mount lateral position left until lag bolts are seated in <br />mounting slots in upper wall channel. (See Figure 2) <br />9. Place two installation washers (G) over two lag bolts (H). <br />(See Figure 2) <br />10. Install two 5/16" x 3-1/2" lag bolts (H) through mounting holes <br />in lower wall channel and into pilot holes. (See Figure 2) <br />11. Place two installation washers (G) over two lag bolts (H). <br />(See Figure 2) <br />12. Tighten all hardware. DO NOT over tighten! <br />Figure 2 <br />Adjusting PDR Height <br />NOTE:Height adjustment range up to 1.08 inches. <br />1. Check PDR for the desired height. If needed, use the <br />adjustment wrench (E) to adjust the PDR height. (See <br />Figure 3) <br />•Turn adjustment nut clockwise to lower the unit height, or <br />•Turn adjustment nut counterclockwise to raise the unit <br />height. <br />Figure 3 <br />1 <br />3 <br />4 <br />5 x 4 <br />3 <br />6 (H) x 2 <br />10 (H) x 2 <br />(G) x 2 <br />(G) x 2 <br />8 <br />9 <br />11 <br />Adjustment nut <br />1 <br />Lower <br />Raise