Laserfiche WebLink
PDR Series Installation Instructions <br />8 <br />Figure 7 <br />x 4 <br />cable clamps <br />(J) <br />1 <br />2 <br />Cable Management <br />WARNING:IMPROPER INSTALLATION CAN LEAD TO <br />SERIOUS PERSONAL INJURY OR DAMAGE TO <br />EQUIPMENT! Make sure cables do not run through pinch <br />points. <br />1. Loosen front and rear cable clamps on top arm. <br />(See Figure 7) <br />2. Thread cable ties (J) under cable clamps and secure clamps <br />to top arm. (See Figure 7) <br />3. Route power/audio/video cables through the cable channel <br />in top arm (See Figure 7), allowing sufficient slack in cables <br />for left/Right movement of display and swing arm and also <br />swing arm extension and retraction. <br />4. Secure cables to top arm using two cable ties (J). <br />5. Repeat Steps 1 through 4, as necessary, for remaining top <br />arm and lower arms. <br />WARNING:IMPROPER INSTALLATION CAN LEAD TO <br />SERIOUS PERSONAL INJURY OR DAMAGE TO <br />EQUIPMENT! DO NOT route cables through holes in <br />faceplate. <br />6. (Optional) Install two cable clips (L) into holes on connector <br />bracket. (See Figure 8) <br />Figure 8 <br />(top view) <br />(L) x 2 <br />connector <br />bracket