Laserfiche WebLink
Gateway Park Center PERKINS+WILL <br /> 810495.000 <br /> 12/06/18 <br /> <br /> <br />DECORATIVE FORMED METAL <br /> 05 75 00 - 2 <br /> <br /> <br />1.4 INFORMATIONAL SUBMITTALS <br />A. Coordination Drawings: For decorative formed metal elements that house items <br />specified in other Sections. Show dimensions of housed items, including locations of <br />housing penetrations and attachments, and necessary clearances. <br />B. Qualification Data: For Installer. <br />C. Evaluation Reports: For post-installed anchors, from ICC-ES. <br />1.5 CLOSEOUT SUBMITTALS <br />A. Maintenance Data: For mirrorlike stainless-steel finish and copper antique finish to <br />include in maintenance manuals. <br />1.6 QUALITY ASSURANCE <br />A. Fabricator Qualifications: A firm experienced in producing decorative formed metal <br />similar to that indicated for this Project and with a record of successful in-service <br />performance as well as sufficient production capacity to produce required units. <br />B. Installer Qualifications: Fabricator of products. <br />C. Mockups: Build mockups to verify selections made under Sample submittals, to <br />demonstrate aesthetic effects, and to set quality standards for fabricati on and <br />installation. <br />1. Build mockups for the following types of decorative formed metal: <br />a. Metal base. <br />2. Subject to compliance with requirements, approved mockups may become <br />part of the completed Work if undisturbed at time of Substantial Completion. <br />1.7 DELIVERY, STORAGE, AND HANDLING <br />A. Deliver decorative formed metal products wrapped in protective coverings and <br />strapped together in suitable packs or in heavy-duty cartons. Remove protective <br />coverings before they stain or bond to finished surfaces. <br />B. Store products on elevated platforms in a dry location. <br />1.8 FIELD CONDITIONS <br />A. Field Measurements: Verify actual locations of walls, columns, beams, and other <br />construction contiguous with decorative formed metal by field measurements <br />before fabrication and indicate measurements on Shop Drawings.