Laserfiche WebLink
Gateway Park Center PERKINS+WILL <br /> 810495.000 <br /> 12/06/18 <br /> <br /> <br />DOOR HARDWARE <br />08 71 00 - 17 <br /> <br /> <br />C. Retrofitting: Install door hardware to comply with manufacturer's published templates <br />and written instructions. Where cutting and fitting are required to install door <br />hardware onto or into surfaces that are later to be painted or finished in another way, <br />coordinate removal, storage, and reinstallation of surface protective trim units with <br />finishing work specified in Division 9 Sections. Do not install surface-mounted items <br />until finishes have been completed on substrates involved. <br />D. Thresholds: Set thresholds for exterior and acoustical doors in full bed of sealant <br />complying with requirements specified in Division 7 Section "Joint Sealants." <br />E. Storage: Provide a secure lock up for hardware delivered to the project but not yet <br />installed. Control the handling and installation of hardware items so that the <br />completion of the work will not be delayed by hardware losses before and after <br />installation. <br />3.4 FIELD QUALITY CONTROL <br />A. Field Inspection: Supplier will perform a final inspection of installed door hardware <br />and state in report whether work complies with or deviates from requirements, <br />including whether door hardware is properly installed, operating and adjusted. <br />3.5 ADJUSTING <br />A. Initial Adjustment: Adjust and check each operating item of door hardware and each <br />door to ensure proper operation or function of every unit. Replace units that cannot be <br />adjusted to operate as intended. Adjust door control devices to compensate for final <br />operation of heating and ventilating equipment and to comply with referenced <br />accessibility requirements. <br />3.6 CLEANING AND PROTECTION <br />A. Protect all hardware stored on construction site in a covered and dry place. Protect <br />exposed hardware installed on doors during the construction phase. Install any and all <br />hardware at the latest possible time frame. <br />B. Clean adjacent surfaces soiled by door hardware installation. <br />C. Clean operating items as necessary to restore proper finish. Provide final protection <br />and maintain conditions that ensure door hardware is without damage or deterioration <br />at time of owner occupancy. <br />3.7 DEMONSTRATION <br />A. Instruct Owner's maintenance personnel to adjust, operate, and maintain mechanical <br />and electromechanical door hardware.