Laserfiche WebLink
Gateway Park Center PERKINS+WILL <br /> 810495.000 <br /> 12/06/18 <br /> <br /> <br />STRETCHED-FABRIC WALL SYSTEMS <br /> 09 77 13 - 6 <br /> <br /> <br />4. Install core material with full coverage, flush with face of stretched-fabric <br />system frame. <br />5. Attach frame and core to substrate with adhesive or fasteners or both to <br />support system and prevent deformation of components. <br />6. Install stretched-fabric systems level and plumb unless otherwise indicated, <br />true in plane, and with fabric square to the grain. <br />7. Install jointed panels with butt joints and reveals as indicated. <br />B. Fabric Installation: Apply fabric monolithically in continuous run over area, without <br />joints or reveals, except where panel joints or midspan frames are indicated. <br />1. Fabric Direction: Run fabric railroaded. <br />2. Fabric Sequence: Maintain sequence of fabric drops; match and level fabric <br />pattern and grain. <br />3. Fabric Alignment: Install fabric with patterns or directional weaves so pattern <br />or weave aligns with adjacent panels. <br />4. Fabric Seams: Sewn seams are not permitted. <br />5. Stretch and secure fabric to frame edges and so frame and frame attachment <br />method are concealed by fabric unless otherwise indicated. <br />6. Stretch fabric tightly and square without puckers, ripples, or distortions. <br />Acclimatize and restretch if recommended by stretched-fabric system <br />manufacturer. Repair distortions, wrinkles, and sagging. <br />3.4 INSTALLATION TOLERANCES <br />A. Edge Straightness: Plus or minus 1/16 inch in 48 inches. <br />B. Variation from Level and Plumb: Plus or minus 1/16 inch in 48 inches, <br />noncumulative. <br />C. Variation of Joint Width: Not more than 1/16 inch in 48 inches from hairline or <br />reveal line, noncumulative. <br />3.5 CLEANING <br />A. Clip loose threads; remove pills and extraneous materials. <br />B. Clean panels on completion of installation to remove dust and other foreign <br />materials according to manufacturer's written instructions. <br />END OF SECTION