Laserfiche WebLink
<br />00800 - 4/13 <br /> <br /> <br />C. After the approval of the list of items required in Paragraph B above, CONTRACTOR <br />shall promptly request Shop Drawings from the various manufacturers, fabricators, and <br />suppliers. CONTRACTOR shall include all shop drawings and other submittals in its <br />certification. <br /> <br />D. CONTRACTOR shall thoroughly review and check the Shop Drawings and each and <br />every copy shall show this approval thereon. <br /> <br />E. If the Shop Drawings show or indicate departures from the Contract requirements, <br />CONTRACTOR shall make specific mention thereof in its letter of transmittal. Failure to <br />point out such departures shall not relieve CONTRACTOR from its responsibility to <br />comply with the Contract Documents. <br /> <br />F. ENGINEER OR OWNERS’ REPRESENTATIVE shall review and approve Shop <br />Drawings within fifteen (15) calendar days from the date received, unless said Drawings <br />are rejected by ENGINEER OR OWNERS’ REPRESENTATIVE for material reasons. <br />ENGINEER OR OWNERS’ REPRESENTATIVE 's approval of Shop Drawings will be <br />general and shall not relieve CONTRACTOR of responsibility for the accuracy of such <br />Drawings, nor for the proper fitting and construction of the work, nor for the furnishing of <br />materials or work required by the Contract Documents and not indicated on the <br />Drawings. No work called for by Shop Drawings shall be performed until the said <br />Drawings have been approved by ENGINEER OR OWNERS REPRESENTATIVE. <br />Approval shall not relieve CONTRACTOR from responsibility for errors or omissions of <br />any sort on the Shop Drawings. <br /> <br />G. No approval will be given to partial submittals of Shop Drawings for items which <br />interconnect and/or are interdependent where necessary to properly evaluate the <br />design. It is CONTRACTOR's responsibility to assemble the Shop Drawings for all such <br />interconnecting and/or interdependent items, check them and then make one submittal <br />to ENGINEER OR OWNERS REPRESENTATIVE along with its comments as to <br />compliance, noncompliance, or features requiring special attention. <br /> <br />H. If catalog sheets or prints of manufacturers' standard drawings are submitted as Shop <br />Drawings, any additional information or changes on such drawings shall be typewritten <br />or lettered in ink. <br /> <br />I. CONTRACTOR shall submit the number of copies required by ENGINEER OR <br />OWNERS REPRESENTATIVE. Resubmissions of Shop Drawings shall be made in the <br />same quantity until final approval is obtained. <br /> <br />J. CONTRACTOR shall keep one set of Shop Drawings marked with ENGINEER OR <br />OWNERS REPRESENTATIVE 's approval at the job site at all times. <br /> <br />