Reso 2024-3716 - Laserfiche WebLink

Home Browse Search

Docusign Envelope ID: 41 F63DOF-3BC8-4149-8618-1 BBEEF49D6F7 subject Schindler Elevator Modernization Proposal - LSUN-D5PJUJ Page 15 of 31 Date 6/4/2024 Related Work by Others Scope Included in Proposal Electrical Work • Furnish and install LED light fixtures in the elevator machine rooms. All lighting in the machine room shall meet 19 -foot candles in all areas. • Replace three-phase mainline disconnect in the elevator machine room. • Furnish and install electrical conduits and wires from the load side of the disconnect to the new elevator controller. • Provide auxiliary contacts for the battery lowering system to new disconnect • Replace cab lights disconnect, provide new conduits and wires from the load side of the disconnect to the new elevator controller. • Provide new GFCI convenience outlets in the Machine Room. • Provide new LED light fixtures in the elevator pit. All lighting in the pit shall meet 10 -foot candles in all areas. • Provide GFCI convenience outlets in the pits. • Provide proper "earth" ground to the new elevator control equipment • Re -use existing main feeders • Install new phone line conduit to elevator controllers • Label all disconnects with source ID • Permits, drawings and Inspections included Mechanical HVAC Work • Provide an air conditioning system in the elevator machine rooms capable of handling the heat loads for these elevators. • Install TWO (2) 1 Ton 12000 BTU'S mini -split units. • Install new drain and refrigeration lines with covers. • Install new condensing units with aluminum brackets and SS hardware. • Fire caulking all penetrations in machine room. • Traveling and lodging is included. • Permits, drawings, coordination and inspections included. General Contracting Work • Provide code compliance machine room door. • Waterproof pit. • Paint machine room ceiling, walls and floor. • Patch hoist way for code compliance. • Work to be perform under Elevator company master permit. Fire Alarm Work • Provide alarm initiating signal wiring to the elevator controller in the machine room that is separated into, (1) primary recall operation (2) secondary recall operation (3) flashing fire hat. • Provide all required code reviews, permits and inspection for a complete system that will initiate fire service recall as required by code. • Add a heat detector in the elevator pit next to sprinkler • Programing, testing and inspection of all new devices included Electrical/Mechanical Engineer Drawings • Survey project with electrical engineer to create electrical and mechanical drawings to pull elevator permit.