Laserfiche WebLink
THE CITY OF SUNNY ISLES BEACH <br />PROJECT NO. 21-1011 <br />BUILDING DEPARTMENT RELOCATION TO ANNEX <br /> <br />Project No. 21-1011 November 2024 095126-7 <br />3.1 EXAMINATION <br />a) Do not proceed with installation until all wet work such as concrete, terrazzo, <br />plastering and painting has been completed and thoroughly dried out. <br />b) Proper designs for both supply air and return air, maintenance of the HVAC filters <br />and building interior space are essential to minimize soiling. Before starting the HVAC <br />system, make sure supply air is properly filtered and the building interior is free o f <br />construction dust. <br />3.2 PREPARATION <br />a) Measure each ceiling area and establish layout of acoustical units to balance border <br />widths at opposite edges of each ceiling. Avoid use of less than half width units at <br />borders and comply with reflected ceiling plans. Coordinate panel layout with <br />mechanical and electrical fixtures. <br />b) WoodWorks ceiling materials should be permitted to reach room temperature and <br />have a stabilized moisture content for a minimum of 72 hours before installation. <br />(Remove plastic wrap to allow panels to climatize). <br />3.3 INSTALLATION <br />a) Interior WoodWorks products, the veneered wood panels are designed for <br />installation in temperature conditions between 50 degrees F and 86 degrees F, in <br />spaces where the building is enclosed, and HVAC systems are functioning and will be <br />in continuous operation. Relative humidity should not fall below 25 percent or exceed <br />55 percent. <br />b) Install suspension system and panels in compliance with ASTM C636, ASTM E580, <br />with the approval of the authorities having jurisdiction, and in accordance with the <br />manufacturer’s WoodWorks Linear Veneered Panels Installation Instructions. <br />3.4 ADJUSTING AND CLEANING <br />a) Replace damaged and broken panels. <br />b) Clean exposed surfaces of ceilings panels, including trim, edge moldings, and <br />suspension members. Comply with manufacturer’s instructions for cleaning and touch <br />up of minor finish damage. <br />END OF SECTION