Laserfiche WebLink
THE CITY OF SUNNY ISLES BEACH <br />PROJECT NO. 21-1011 <br />BUILDING DEPARTMENT RELOCATION TO ANNEX <br /> <br />Project No. 21-1011 November 2024 054000 Cold-Formed Metal Framing-5 <br /> <br />C. Expansion Anchors: Fabricated from corrosion-resistant materials, with capability to <br />sustain, without failure, a load equal to 5 times design load, as determined by testing per <br />ASTM E 488 conducted by a qualified independent testing agency. <br /> <br />D. Power-Actuated Anchors: Fastener system of type suitable for application indicated, <br />fabricated from corrosion-resistant materials, with capability to sustain, without failure, a <br />load equal to 10 times design load, as determined by testing per ASTM E 1190 conducted <br />by a qualified independent testing agency. <br /> <br />E. Mechanical Fasteners: ASTM C 1513, corrosion-resistant-coated, self-drilling, self-tapping <br />steel drill screws. <br /> <br /> 1. Head Type: Low-profile head beneath sheathing, manufacturer's standard <br />elsewhere. <br /> <br />F. Welding Electrodes: Comply with AWS standards. <br /> <br />2.6 MISCELLANEOUS MATERIALS <br /> <br />A. Galvanizing Repair Paint: SSPC-Paint 20 or DOD-P-21035. <br /> <br />B. Sealer Gaskets: Closed-cell neoprene foam, 1/4 inch thick, selected from manufacturer's <br />standard widths to match width of bottom track or rim track members. <br /> <br />2.7 FABRICATION <br /> <br />A. Fabricate cold-formed metal framing and accessories plumb, square, and true to line, and <br />with connections securely fastened, according to referenced AISI's specifications and <br />standards, manufacturer's written instructions, and requirements in this Section. <br /> <br />1. Fabricate framing assemblies using jigs or templates. <br /> <br />2. Cut framing members by sawing or shearing; do not torch cut. <br /> <br />3. Fasten cold-formed metal framing members by welding, screw fastening, clinch <br />fastening, or riveting as standard with fabricator. Wire tying of framing members <br />is not permitted. <br /> <br />a. Comply with AWS D1.3 requirements and procedures for welding, <br />appearance and quality of welds, and methods used in correcting welding <br />work. <br />b. Locate mechanical fasteners and install according to Shop Drawings, with <br />screw penetrating joined members by not less than three exposed screw <br />threads. <br /> <br />4. Fasten other materials to cold-formed metal framing by welding, bolting, or screw <br />fastening, according to Shop Drawings. <br /> <br />B. Reinforce, stiffen, and brace framing assemblies to withstand handling, delivery, and <br />erection stresses. Lift fabricated assemblies to prevent damage or permanent distortion. <br /> <br />C. Fabrication Tolerances: Fabricate assemblies’ level, plumb, and true to line to a maximum <br />allowable tolerance variation of 1/8 inch in 10 feet and as follows: