Laserfiche WebLink
THE CITY OF SUNNY ISLES BEACH <br />PROJECT NO. 21-1011 <br />BUILDING DEPARTMENT RELOCATION TO ANNEX <br /> <br />Project No. 21-1011 November 2024 055000 Miscellaneous Metals-20 <br /> <br /> <br /> <br />A. Galvanizing: Hot-dip galvanize items as indicated to comply with ASTM A 153/A 153M for <br />steel and iron hardware and with ASTM A 123/A 123M for other steel and iron products. <br /> <br />1. Do not quench or apply post galvanizing treatments that might interfere with paint <br />adhesion. <br /> <br />B. Preparation for Shop Priming Galvanized Items: After galvanizing, thoroughly clean railings <br />of grease, dirt, oil, flux, and other foreign matter, and treat with metallic phosphate <br />process. <br /> <br />C. Shop prime iron and steel items [ not indicated to be galvanized] unless they are to be <br />embedded in concrete, sprayed-on fireproofing, or masonry, or unless otherwise indicated. <br /> <br />1. Shop prime with [universal shop primer] [primers specified in Section 099113 <br />"Exterior Painting"] [primers specified in Section 099123 "Interior Painting"] unless <br />[zinc-rich primer is] [primers specified in Section 099600 "High-Performance <br />Coatings" are] indicated. <br /> <br />D. Preparation for Shop Priming: Prepare surfaces to comply with [SSPC-SP 6/NACE No. 3, <br />"Commercial Blast Cleaning."] [SSPC-SP 3, "Power Tool Cleaning."] [requirements <br />indicated below:] <br /> <br />1. Exterior Items: SSPC-SP 6/NACE No. 3, "Commercial Blast Cleaning." <br /> <br />2. Items Indicated to Receive Zinc-Rich Primer: SSPC-SP 6/NACE No. 3, "Commercial <br />Blast Cleaning." <br /> <br />3. Items Indicated to Receive Primers Specified in Section 099600 "High-Performance <br />Coatings": SSPC-SP 6/NACE No. 3, "Commercial Blast Cleaning." <br /> <br />4. Other Items: SSPC-SP 3, "Power Tool Cleaning." <br /> <br />E. Shop Priming: Apply shop primer to comply with SSPC-PA 1, "Paint Application Specification <br />No. 1: Shop, Field, and Maintenance Painting of Steel," for shop painting. <br /> <br />1. Stripe paint corners, crevices, bolts, welds, and sharp edges. <br /> <br />2.28 ALUMINUM FINISHES <br /> <br />A. As-Fabricated Finish: AA-M12. <br /> <br />B. Clear Anodic Finish: AAMA 611, Class I, AA-M12C22A41. <br /> <br />PART 3 - EXECUTION <br /> <br />3.1 INSTALLATION, GENERAL <br /> <br />A. Cutting, Fitting, and Placement: Perform cutting, drilling, and fitting required for installing <br />metal fabrications. Set metal fabrications accurately in location, alignment, and elevation; <br />with edges and surfaces level, plumb, true, and free of rack; and measured from <br />established lines and levels. <br />