Laserfiche WebLink
<br />A, The Security system Installer shall insure that connections to locks, door switches, control <br />panels and consoles are complete and properly terminated, <br /> <br />B. All conductors shall meet or exceed manufacture's minimum wire size for device, application, <br />and length of run, and shall be installed in common raceways and equipment enclosures with <br />other conductors. <br /> <br />C. Wiring systems shall use stranded copper conductors. <br /> <br />0, Wiring systems shall be individually color-coded, All colors shall be continuous from filed device <br />to last internal termination point. Colors shall be consistent as to function, i,e" Red-24VOC <br />positive, Black-24VOC negative. White or grey conductors shall be used only for neutral <br />conductors and green only for grounding conductors. <br /> <br />E. Conductors within junction and pull boxes and equipment enclosures shall be grouped and <br />laced with nylon tie straps with identification tab, in individual sets serving individuallocksets or <br />operating mechanisms. Conductor groups shall be identified on the strap tab with respect to <br />room or operator served. <br /> <br />F. Security system conductors shall not be spliced; conductors shall be continuous between <br />locksets and/or operators and terminations point for control. <br /> <br />G. Junction boxes and pull boxes required for installation of the security system wiring must be <br />installed to be fully accessible, Work under this section of the specification must be closely <br />coordinated with work of all other trades to comply with this requirement. <br /> <br />3.4. EQUIPMENT INSTALLATION <br /> <br />A, Hardware, screws, bolts, nuts, components and accessory fittings shall be of a type designed, <br />intended or appropriate for the use, and complement the items with which they are used, and <br />shall have corrosion protection suitable for the atmosphere in which they are installed. <br /> <br />B. Equipment, except portable equipment, shall be held firmly in place, This shall include <br />amplifiers, cameras, monitors, cables, Etc. Fastening and supports shall be adequate to <br />support their loads with a safety factor of at least five. Switches, connectors, outlets, etc., shall <br />be clearly, logically and permanently labeled during installation. <br /> <br />C. The Security System Installer must take such precautions as are necessary to guard against <br />electro-magnetic and electro-static hum; to supply adequate ventilation; and to install the <br />equipment so as to provide maximum safety to the operator. <br /> <br />0, Care shall be exercised in wiring, so as to avoid damage to the cable and to the equipment. <br />Joints and connections shall be made with resin-core solder or with mechanical connectors. <br />Wiring shall be installed in strict adherence to standard professional practices. <br /> <br />E, Equipment shall have an engraved or photo laminated label identifying area served by that <br />device. <br /> <br />3,5, PROTECTION OF EQUIPMENT <br /> <br />A, Security equipment is sensitivity to dust, dirt, condensing humidity and other products normally <br />found on construction sites. The Security System Installer shall take necessary precautions to <br />insure that equipment is properly stored and protected. Failure to meet this criterion shall result <br />in the replacement of exposed equipment at the discretion of the Ovmer or Owner's <br />representative. <br /> <br />8/04 <br /> <br />17715-5 <br /> <br />SIB <br />