Specifications Vol. II - Laserfiche WebLink

Home Browse Search

..., . n .., structural steel appears to be defective during the cleaning operation, notify the Engineer immediately. After repairs are completed, clean and coat the repaired sections per this Specification. Cover all motors, gears and electrical apparatus not to be coated and may be damaged by surface preparations. Ensure all bridge components are kept free of abrasive materials buildup at all times. 560-15.2 Testing of Original Coating: When sound portions of the original coating are to be left in place, prior to the commencement of cleaning and coating operations, apply a test patch (minimum area of 100 ft2 [9.3 m2]) of the proposed coating system in accordance with this Specification and have it evaluated by the Engineer for approval. Allow the test patch to cure a minimum of 7 days prior to evaluation. Ensure the test patch meets all Specification requirements and also exhibit a minimum adhesion rating of 4A when tested in accordance with ASTM D 3359. Repair damage, which occurs as a result of testing in accordance with this Specification. 560-15.3 Application of Coating: Apply an overall coating system to all surface in accordance with the manufacturers recommendations and the Contract Documents. . . r'1 . ..., . ..., . ,.., . ., 560-16 Lead Abatement. 560-16.1 Coating Hazardous Material Analysis: When the Contract includes removal of paint from an existing structure the Coating Hazardous Material Analysis Data Sheet will be available on the Department's web site. The URL for obtaining this information is: http://www.dot.state.fl.us/statematerialsoffice/laboratory / chemical/hazardouscoati ngs/inde x.htm. 560-16.2 General: Establish a hazardous coating removal program to document and control coating removal and application operations in strict compliance with OSHA 29CFR Part 1910.1025, 1926.62, and 1926.63. This program will include applicable requirements from Environmental Protection Agency (EPA) environmental protection issues and hazardous waste disposal. Prior to construction of the containment area or removing any hazardous materials perform Total Suspended Particulate (TSP) sampling and testing of the air and soil for any hazardous materials. Document the number and specific location where each sample is taken as outlined in Project Design - Industrial Lead Paint Removal Handbook, Volume 2 and use these results to determine a baseline level of any hazardous materials on the job site. Continue the TSP monitoring from the beginning of work to the removal of the containment devices. Workday determination constitutes only the time during which cleaning and surface preparation and subsequent clean up is performed. Enter all pertinent information into a field logbook. For the purposes of computing action levels, the workday must not exceed 8 hours. 560-16.3 Pollution Control: Submit a written pollution control and monitoring plan at the preconstruction meeting which clearly describes the means for complying with all Local, State and federal regulations including pollution control provisions specified herein. The written plan must be in accordance with Project Design: Industrial Lead Paint Removal Handbook, Volume II, Phase 6, Environmental Monitoring and Phase 7, Worker Protection and specifically include, but not be limited to, providing a scaled map of the work site layout showing the proposed number and location of soil and sediment sampling, waste I' . . II . ..." . ,..., . ..., . II . II . r'1 . II . I' . .. 1 09/09 01 000-1 35 03-4122.F .