Laserfiche WebLink
<br />...., <br /> <br />. <br /> <br />...., <br /> <br />.., <br />. <br /> <br />990-9.5 Trailer Mounted Unit: Ensure the trailer meets the following: <br />(1) The trailer shall be painted Omaha orange, Federal Standard 595-B, <br />Number 12243. <br />(2) The trailer shall be equipped with class-A lights, using a plug adaptor. <br />(3) The trailer shall be equipped with adjustable outrigger leveling pads <br />(screw-type), one on each of the four frame corners, designed to be set up at the site with <br />its own chassis and outriggers, without being hitched to a vehicle. <br />(4) The trailer shall be a see through design (no box designs) equipped with <br />fenders over the tires and shall be made from heavy-duty metal sufficient to allow a person <br />to stand and operate or perform maintenance on the unit. <br />(5) The trailer shall meet all equipment specifications set forth In <br />Chapter 316 of the Florida Statutes, and by such rule, regulation or code that may be <br />adopted by the Department of Highway Safety and Motor Vehicles. <br />990-9.6 Traffic Counter: The unit shall be fitted with a device, which counts the <br />number of vehicles passing the Radar Speed Display Unit. The counter device shall be <br />capable of: <br />(1) Digital readout of the number of vehicles passing the radar speed display <br /> <br />. <br /> <br />..., <br /> <br />. <br /> <br />PI <br /> <br />. <br /> <br />..., <br />. <br /> <br />.., <br /> <br />. <br /> <br />..., <br /> <br />unit. <br /> <br />. <br /> <br />(2) Digital readout of the number of vehicles exceeding the speed shown on <br />the radar speed display unit. <br /> <br />,., <br /> <br />-, <br /> <br />990-10 Safety Warning Transmitter. <br />990-10.1 General: Manufacturers providing the device described herein shall <br />provide a certified test report to the Engineer indicating the device meets these <br />specification requirements. <br />990-10.2 Output Frequency: <br />(1) 24.1 GHz. <br />(2) Maximum Output Power; 25 milliwatts per square meter at 3 meters. <br />(3) Output Beam; 23 inches [.584 m] maximum vertical, 25 inches [.4 m] <br />maximum horizontal beam width at 3dBC points, vertically polarized (if transmitter is <br />horizontally mounted). <br />(4) Input Power; + 11.0 to + 16.0 volts DC. Negative ground, maximum <br />current 0.75 amperes, except initial surge maximum of 1.5 amperes. <br />(5) Data Transmission; Either of two output messages selected depending <br />upon speed of host vehicle relative to programmed threshold speed (stationary message <br />and moving message). Capable of transmitting multiple advanced warning messages at <br />least 2 miles. <br />(6) Threshold Speed; 10 mph [16 km]. <br />(7) Field Programmability; Output messages may be programmed by PC or <br />terminal using optional accessory cable. <br /> <br />. <br /> <br />..., <br /> <br />. <br /> <br />..., <br /> <br />. <br /> <br />" <br />. <br /> <br />. <br /> <br />...., <br /> <br />. <br /> <br />-. <br /> <br />. <br /> <br />. <br /> <br />990-11 Temporary Traffic Control Signals. <br />990-11.1 General: Meet the physical display and operational requirements of <br />conventional traffic signal described in the MUTCD for portable traffic signals. The <br />standard includes but is not limited to the following: <br />(1) Use signal heads having three 12 inches [305 mm] vehicular signal <br />indications (Red, Yellow and Green). Ensure there are two signal heads for each direction <br />of traffic. <br /> <br />..., <br /> <br />. <br /> <br />..., <br /> <br />- <br /> <br />. <br /> <br />, <br /> <br />09/09 <br /> <br />01000-210 <br /> <br />03-4122.F <br /> <br />. <br />