Specifications - Laserfiche WebLink

Home Browse Search

6.15 Hazard Communication Programs and other data as Engineer may require to enable Engineer to review the submittal for A. Contractor shall be responsible for coordi- the limited purposes required by Paragraph nating any exchange of material safety data sheets 6.17.D. or other hazard communication information required to be made available to or exchanged between or B. Where a Shop Drawing or Sample is re- among employers at the Site in accordance with quired by the Contract Documents or the Schedule Laws or Regulations. of Submittals , any related Work performed prior to Engineer's review and approval of the pertinent 6.16 Emergencies submittal will be at the sole expense and responsibility of Contractor. A. In emergencies affecting the safety or protection of persons or the Work or property at the C. Submittal Procedures Site or adjacent thereto, Contractor is obligated to act to prevent threatened damage, injury, or loss. 1. Before submitting each Shop Drawing or Contractor shall give Engineer prompt written notice Sample, Contractor shall have determined and veri- if Contractor believes that any significant changes in fled: the Work or variations from the Contract Documents have been caused thereby or are required as a a. all field measurements, quantities, dimen- result thereof. If Engineer determines that a change sions, specified performance and design in the Contract Documents is required because of criteria, installation requirements, materials, the action taken by Contractor in response to such catalog numbers, and similar information an emergency, a Work Change Directive or Change with respect thereto; Order will be issued. b. the suitability of all materials with respect 6.17 Shop Drawings and Samples to intended use, fabrication, shipping, han- dling, storage, assembly, and installation A. Contractor shall submit Shop Drawings pertaining to the performance of the Work; and Samples to Engineer for review and approval in accordance with the acceptable Schedule of c. all information relative to Contractor's Submittals (as required by Paragraph 2.07). Each responsibilities for means, methods, tech- submittal will be identified as Engineer may require. niques, sequences, and procedures of construction, and safety precautions and 1. Shop Drawings programs incident thereto; and a. Submit number of copies specified in the d. shall also have reviewed and coordinated General Requirements. each Shop Drawing or Sample with other Shop Drawings and Samples and with the b. Data shown on the Shop Drawings will be requirements of the Work and the Contract complete with respect to quantities, dimen- Documents. sions, specified performance and design criteria, materials, and similar data to show 2. Each submittal shall bear a stamp or Engineer the services, materials, and specific written certification that Contractor has satis- equipment Contractor proposes to provide fled Contractor's obligations under the Contract and to enable Engineer to review the Documents with respect to Contractor's review and information for the limited purposes required approval of that submittal. by Paragraph 6.17.D. 3. With each submittal, Contractor shall give 2. Samples: Contractor shall also submit Engineer specific written notice of any variations, Samples to Engineer for review and approval in that the Shop Drawing or Sample may have from the accordance with the acceptable schedule of Shop requirements of the Contract Documents. This notice Drawings and Sample submittals. shall be both a written communication separate from the Shop Drawing's or Sample Submittal; and, in a. Submit number of Samples specified in addition, by a specific notation made on each Shop the Specifications. Drawing or Sample submitted to Engineer for review and approval of each such variation. b. Clearly identify each Sample as to material, Supplier, pertinent data such as D. Engineer's Review catalog numbers, the use for which intended EJCDC C-700 Standard General Conditions of the Construction Contract. Copyright 02002 National Society of Professional Engineers for EJCDC. All rights reserved. 00700-24 03/12 11-4179