Laserfiche WebLink
4 Select Optional Accessories <br /> Optional Ceiling Access Door (2' x 2' [60 x 60 cm]) to allow access above finished ceiling (highly recommended). <br /> White Painted Finish Accepts Ceiling Tile <br /> Optional Environmental Air Space Housing: Optional ceiling closure panel not included (see page 3). <br /> SLX SLXR <br /> Optional Ceiling Closure Panel: Pairs with Environmental Air Space Housing. Installs with ceiling trim lip or as Lipless Closure (see page 3). <br /> SLX SLXR <br /> Optional Ceiling Finish Kit: Ceiling closure panel and mating trim kit used to finish ceiling opening when no Air Space Housing is needed (see page 3). <br /> SLX SLXR <br /> Optional Universal Projector Mount (max. load 26 lbs.). <br /> Optional Current Sensor. (Please Note: Optional Current Sensor may reduce projector space available. Contact Draper). <br />5 Select factory installed hookup for RGB, Video and Projector Control? <br />(Note: Cables are Optional, not plenum rated and are shielded) <br /> Yes No <br /> What type of connectors do you need? (Inputs to Projector and Outputs at top of Lift) <br /> BNC How Many? <br /> 15 Pin HD How Many? <br /> RCA How Many? <br /> S-Video How Many? <br /> RS232 (DB9) How Many? <br /> Cat 6 How Many? <br /> HDMI How Many? * Please note: There is a limit of seven (7) video, RGB and control cables per Scissor Lift. <br />6 Select Voltage: <br /> 110-120V <br /> 220-230V <br />7 Select Low Voltage Controls: This unit comes with one 3-Button Wall Switch and one Momentary Key Control. <br /> For other switching options, please select from below: <br /> Replace 3-Button Wall Switch with optional second Momentary Key Control (SP-KSM) <br /> Optional Key Operated Power Supply Key Switch (On-off) <br /> Optional Wireless Remote Control (radio frequency transmitter & receiver) (Controls the "Show" position only) <br /> Optional Wireless Remote Control (infrared transmitter & receiver) (Controls the "Show" position only) <br /> Optional R2D7 RS232 interface for Serial Communication (Controls the "Show" position only) <br />8 Will this unit be controlled by other equipment? <br /> No. <br /> Yes. What kind of equipment? <br />Scissor Lift Submittal & Planning Sheet for SLX Series page 2 of 4 <br />(765) 987-7999www.draperinc.com <br />Lipless Ceiling Closure Dimensions (Optional) <br />SLX SLXR <br />Width 391/8" (994 mm)391/8" (994 mm) <br />Depth 391/8" (994 mm)451/8" (1146 mm) <br />Lipless Closure Option is available by removing the Trim Ring from the <br />Closure Panel. A substrate material (ceiling tile, gypsum board, etc.) can be attached <br />directly to the Closure Panel using adhesive, double-sided tape or screws. <br />NOTE: Make sure the added weight of the substrate does not exceed the stated <br />weight capacity of the lift. Substrate should be installed so that it is centered within <br />the finished opening in the ceiling, with a gap of no less that 3/16" around all edges. DRAPER SALESPERSON: <br />CUSTOMER CONTACT: <br />SIGNATURE: <br />SLX Scissor Lift — Dimensions & Data <br />SLX10 SLX14 SLX17 SLX21 SLX24 SLX28 <br />Height of lift in closed position1 141/16" (36 cm)165/16" (41 cm)189/16" (47 cm)2013/16" (53 cm)231/16" (59 cm)255/16" (64 cm) <br />Max. down travel <br />(to service position)10'7" (323 cm)14'2" (432 cm)17'8" (538 cm)21'3" (648 cm)24'9" (754 cm)28'5" (866 cm) <br />Net weight—lbs.213 230 260 275 289 303 <br />Net weight—kg 98 104 118 125 131 137 <br />Approx. travel time2 <br />(to service position)1 min. 43 sec.2 min. 24 sec.2 min. 55 sec.3 min. 36 sec.4 min. 7 sec.4 min. 48 sec. <br />1 Height of Scissor Lift in closed position only. Overall height of projector, plus optional mount, plus optional ceiling closure, <br /> plus optional Environmental Air Space Housing adds to overall height of equipment installed above ceiling. <br />2 Up direction with full load of 350 lbs. "Down" travel time or lighter loads will have shorter travel times.