Laserfiche WebLink
Page 9 <br />MOUTNING THE BOX TO WALL STUDS (CONTINUED) <br />NOTE: For information about connecting power to the outlet, see “Connecting Power to the F7526-V1 <br />Duplex Outlet” on page 13. <br />5. Attach any grommets (not provided) to the box, as desired. <br />6. Pass signal and power cables through all knockouts on the box. <br />7. Remove and discard any pre-installed screws from the Decora <br /> outlet prior to installation. (FIGURE G) <br />8. From the inside of the box, secure the included F7526-V1 duplex outlet power kit’s junction box (C), <br /> Decora outlet (D), and plate (E) to the desired location using the (4x) J-Box screws (F) as shown. <br /> (FIGURE H) <br />FIGURE H <br />FIGURE G <br /> <br />WARNING: All wiring should be installed by a licensed electrician following all local codes and <br />ordinances. <br />AVERTISSEMENT: Tout le câblage doit être installé par un électricien agréé suivant tous les <br />codes et règlements locaux. <br />NOTE: Holes fit 1 3/4” grommets <br />(not provided). <br />Remove and discard <br />pre-installed screws. <br />C <br />E <br />D <br />F