Laserfiche WebLink
Gateway Park Center PERKINS+WILL <br /> 810495.000 <br /> 12/06/18 <br /> <br /> <br />QUALITY REQUIREMENTS <br />01 40 00 - 7 <br /> <br /> <br />5. Submit additional copies of each written report directly to authorities having <br />jurisdiction, when they so direct. <br />C. Retesting/Reinspecting: Regardless of whether original tests or inspections were <br />Contractor's responsibility, provide quality-control services, including retesting and <br />reinspecting, for construction that replaced Work that failed to comply with the <br />Contract Documents. <br />D. Testing Agency Responsibilities: Cooperate with Architect and Contractor in <br />performance of duties. Provide qualified personnel to perform required tests and <br />inspections. <br />1. Notify Architect and Contractor promptly of irregularities or deficiencies <br />observed in the Work during performance of its services. <br />2. Determine the locations from which test samples will be taken and in which <br />in-situ tests are conducted. <br />3. Conduct and interpret tests and inspections and state in each report whether <br />tested and inspected work complies with or deviates from requirements. <br />4. Submit a certified written report, in duplicate, of each test, inspection, and <br />similar quality-control service through Contractor. <br />5. Do not release, revoke, alter, or increase the Contract Document <br />requirements or approve or accept any portion of the Work. <br />6. Do not perform duties of Contractor. <br />E. Manufacturer's Field Services: Where indicated, engage a factory-authorized service <br />representative to inspect field-assembled components and equipment installation, <br />including service connections. Report results in writing as specified in <br />Section 01 33 00 "Submittal Procedures." <br />F. Manufacturer's Technical Services: Where indicated, engage a manufacturer's <br />technical representative to observe and inspect the Work. Manufacturer's technical <br />representative's services include participation in preinstallation confer ences, <br />examination of substrates and conditions, verification of materials, observation of <br />Installer activities, inspection of completed portions of the Work, and submittal of <br />written reports. <br />G. Associated Contractor Services: Cooperate with agencies and representatives <br />performing required tests, inspections, and similar quality-control services, and <br />provide reasonable auxiliary services as requested. Notify agency sufficiently in <br />advance of operations to permit assignment of personnel. Provide the followi ng: <br />1. Access to the Work. <br />2. Incidental labor and facilities necessary to facilitate tests and inspections. <br />3. Adequate quantities of representative samples of materials that require <br />testing and inspection. Assist agency in obtaining samples. <br />4. Facilities for storage and field curing of test samples. <br />5. Preliminary design mix proposed for use for material mixes that require <br />control by testing agency. <br />6. Security and protection for samples and for testing and inspection equipment <br />at Project site. <br />H. Coordination: Coordinate sequence of activities to accommodate required quality- <br />assurance and quality-control services with a minimum of delay and to avoid