Reso 98- 31 - Laserfiche WebLink

Home Browse Search

76-110-0625/D, Issue 1 —TT'c'71_AV' f=. - +°�tC.tL.v1" ✓—E�-YY-y ✓V J� The fact that your system is in TAPI /CSV mode does not prevent normal use of your telephone set, as long as TAPI /CSV is in idle state. You cannot, �M however, dial from both the PC and the telephone set at the same time. , Functions such as Hold, Transfer, Speed dial and Conference can only be performed from the telephone set. 6.3 INSTALLATION OF THE UNIVERSAL DATA INTERFACE (UDI) CARD For complete instructions on installing, configuring and operating the UDI card, refer to the Universal Data Card Manual, listed above in Applicable Documentation. In brief, to install the UDI card: 1. Disconnect the handset and line wires from the telephone set. 2. Remove the screws from the telephone set base and remove the base. 3. Remove the rectangular cutout from the rear of the telephone set base, using a utility knife. 4. Insert the UDI card (refer to specific instructions for each type of tele- phone set in Section 3 of the UDI Card Manual). 5. Replace the telephone set base and reconnect the handset and line wires. 6. Connect the adapters to the PC and to the telephone set and the cable to the adapters (refer to `specific instructions for each set in Section 3 of the UDI Card Manual). The current version of TAPI is included in the UDI card software version 4.05 and higher. II The UDI card has two operating modes: Circuit Switched Data and Circuit Switched Voice. " •_ TAPI /CSV is the default mode. You can change the mode, either from the PC or from the 1. telephone set, once the application is setup. To switch to TAPI /CSV mode using a terminal or PC Use the %AO command to switch modes. For TAPI /CSV mode the code is 4. • Enter the command AT %AO =4 in the Windows ACCESSORIES Screen, in the TERMINAL dialog box. p �- To switch to TAPI /CSV mode using a telephone dialpad ~ 1. Remove the line cord. ' 2. Press either [SPD /PROGJ (switches the mode only) or J #J (switches the mode and resets the NOVRAM). 3. Continue pressing the key down for approximately five seconds - until the mode appears on the display - while at the same time cord. reinserting the line The UDI card switches to TAPI /CSV mode. The parameters in the profile are updated to the settings for TAPI /CSV mode. Once installed and configured, the UDI card works in synchronous and parallel to the telephone set. When you enter a command using the PC, it is the same as if you performed the same function on the telephone set.