Laserfiche WebLink
<br />SECTION 02841 <br /> <br />SIGNAGE <br /> <br />PART 1 - GENERAL <br /> <br />1.01 SUMMARY <br /> <br />A. Section includes: Signage indicated on drawings and specified in this section. <br /> <br />B. Related Sections: <br /> <br />1. Division 16 - Electrical. <br /> <br />1.02 REFERENCES <br /> <br />A National Association of Architectural Metal Manufacturers (NAAMM) "Metal <br />Finishes Manual". <br />B. American Welding Society <br />AWS D1.1 uStructural Welding Code, Steel", and <br />AWS D1.2 uStructural Welding Code, Aluminum", <br />C. Underwriters Laboratories, Inc. (UL) <br />Standards for Safety, UL Publication 48 '4Electric Signs". <br /> <br />1.03 SUBMITTALS <br /> <br />A. Submit properly identified manufacturer's literature and technical data before <br />commencing Work. <br /> <br />1. <br /> <br />Shop Drawings: Submit Shop Drawings for approval by CONSULTANT <br />Furnish elevations, details of fabrication and erection, including all materials, <br />shapes, dimensions, finishes, design loads. anchorage, and method of <br />connections. Show dimensions ofletters and logo forms. Engineering plans <br />and footing details shall be signed and sealed by a state of Florida registered <br />engineer. All plans and details must meet South Florida Building Code <br />requirements including wind loading requirements. <br /> <br />2. <br /> <br />Paint and Material Samples: Fabricator must match all custom paint and <br />materials as specified by CONSULTANT. <br /> <br />/' <br /> <br />Submit (2) sets of (for review lapproval by CONSULTANT) non- <br />returnable samples of each custom and standard color, material or finish <br />as specified in these design documents. Then submit (3) sets of each <br />approved custom and standard colors and finishes on the actual materials. <br /> <br />02841-1 <br /> <br />/l <br /> <br />Exhibit "A" <br />