Laserfiche WebLink
4.15 PATCHING OF LIFT LOOPS: <br />Prior to driving piles in a marine or fresh water location, cut off <br />and patch embedded lifting loops at elevations higher than 10 feet below the <br />mudline using materials and methods as recommended by the Manufacturer. <br />4.16 MANUFACTURING TOLERANCES: <br />A. Length ..... +6 in., -2 in. <br />B. Width or diameter .....t3 /8 in.. <br />C. Sweep (variation from straight line parallel to centerline of pile) <br />(considered to be a form tolerance) .....t1 /8 in. per 10 ft. <br />D. Position of tendons .....t' /4 in. <br />E. Wall thickness ..... -'/4 in., +'/z in. <br />F. Position of handling devices ..... +6 in. <br />G. Position of steel driving tips .....±% in.. <br />H. Variation from specified end squareness or skew ..... t' /4 in. per 12 <br />in., t'h in. max. <br />I. Local straightness any surface .....t' /4 in. per 10 ft. <br />J. Longitudinal spacing of spiral reinforcement .....t' /4 in. <br />5.0 STEEL TIE RODS: <br />5.1 Material <br />TS -23 <br />RJCj0&WSUNNY ISLESRECHSPECS <br />