Laserfiche WebLink
<br />D, System should be network-ready using standard Ethernet/Fast Ethernet UTP connection, <br /> <br />E, System shall have the capability to send e-mail and/or page in the event of camera loss or <br />programmed event. <br /> <br />F, System must be scalable by "daisy-chaining" or similar method to allow for future expansion. <br /> <br />G, System must be capable of easily exporting stored video for law enforcement use. <br /> <br />H. Acceptable products: <br /> <br />1. American Dynamics DigiMux <br /> <br />2, or approved equal <br /> <br />2.4. POWER SUPPLY <br /> <br />A. System installer shall provide power supply units as necessary to make the system complete <br />and functional. Power supplies may be required for main and remote equipment. Power supplies <br />are to be selected to match source and load voltages, frequency, wattage and environment for <br />equipment powered. Sufficient capacity shall be included in power supplies to accommodate <br />reasonable and expected future requirements. Power supply shall be U.L listed. <br /> <br />B. Power supply enclosure shall be suitable for location used. Power supplies are to be located in <br />central communications closets along with DVR units, <br /> <br />C, Provisions shall be made for the continuous operation of the full system upon loss of normal <br />power. Standby batteries, UPS system, or both shall provide power for minimum of 24 hours for <br />remote devi ces, and 30 minutes for servers, monitors and common equipment. Generator <br />standby power (not provided by security installer) shall provide emergency long-term power. <br /> <br />2.5. EQUIPMENT HOUSING <br /> <br />A. Equipment housing shall be provided where indicated on the drawings and as needed to house <br />security equipment and control system components such as programmable logic controllers, <br />wiring terminations, power supplies, auxiliary relays, etc, <br /> <br />PART 3 EXECUTION <br /> <br />3.1. SECURITY EQUIPMENT CABINET INSTALLATION <br /> <br />A. Coordinate installation of equipment cabinets with millwork construction with respect to <br />dimensions, installation and accessibility. Full accessibility must be maintained as required by <br />the National Electrical Code. <br /> <br />B, Wall hung cabinets shall have adequate wall blocking to support full weight of cabinets and <br />installed equipment. <br /> <br />C, Power and cabling shall be coordinated to enter cabinets without producing trip hazards. <br /> <br />3.2, ADDITIONAL SYSTEM PROGRAMMING NOTES <br /> <br />A. Provide fully functional and programmed system(s) to Owner's requirements, <br /> <br />3,3, WIRING INSTALLATION <br /> <br />8/04 <br /> <br />17725-5 <br /> <br />SIB <br />