Reso 2010-1605 - Laserfiche WebLink

Home Browse Search

Contractor shall assume appropriate responsibility for such performance and shall bear an appropriate amount of the attributable costs for correction. 3.4.2 The Conlractor shall take field measurements and verify field conditions and shall carefull y compare such field measurements and conditions and other information known to the Contractor with the Contract Documents before commencing activities. Errors, inconsistencies or omissions discovered shall be reported in writing to the NE and City's Representative within twenty-four (24) hours. During the progress of work, Contractor shall verify all field measurements prior to fabrication of building components or equipment, and proceed with the fabrication to meet field conditions. Contractor shall consult all Contract Documents to determine the exact location of all work and verify spatial relationships of all work. Any question concerning said location or spatial relationships shall be submitted to the City's Representative. Specific locations for equipment, pipelines, ductwork and other such items of work, where not dimensioned on plans, shall be determined in consultation with City's Representative and NE. Contractor shall be responsible for the proper fitting of the Work in place, 3.4.3 Should the Contract Documents fail to particularly describe materials or goods to be used, it shall be the duty of the Contractor to inquire of the NE and the City's Representative what is to be used and to supply it at the Contractor's expense, or else thereafter replace it to the City's Representative's satisfaction. At a minimum, the Contractor shall provide the quality of materials as generally specified throughout the Contract Documents. 3.4.4 Contractor shall not be entitled to an adjustment in the Contract time or an adjustment in the Contract Amount if a change or Work is required due to an error, inconsistency, omission or violation that the Contractor failed to timely report. 3.4.5 Contractor shall be responsible for inspection of portions of Work already performed under Contract to determine that such portions are in proper condition to receive subsequent Work. 3.5 Cleaning and Removal 3.5.1 The Contractor shall keep the Work site and surrounding areas free from accumulation of waste materials, rubbish, debris, and dirt resulting from the Work and shall clean the Work site and surrounding areas as requested by the NE and the City's Representative, including mowing of grass greater than 6 inches high. The Contractor shall be responsible for the cost of clean up and removal of debris from premises. The building and premises shall be kept clean, safe, in a workmanlike manner, and in compliance with OSHA standards at all times. At completion of the Work, the Contractor shall remove from and about the Work site tools, construction equipment, machinery, fencing, and surplus materials. Further, at the completion of the work, all dirt, stains, and smudges shall be removed from every part of the building, all glass in doors and windows shall be washed, and entire Work shall be left broom clean in a finished state ready for occupancy. The Contractor shall advise his Subcontractors of any tier of this provision. and the Contractor shall be fully responsible for leaving the premises in a finished state ready for use to the satisfaction of the City's Representative. If the Contractor fails to comply with the provisions of this paragraph, the City may do so and the cost thereof shall be charged to the Contractor. ~ 12