Specifications Vol. II - Laserfiche WebLink

Home Browse Search

..... . .., Dynamic Shear G'sin 0, Rheometer, AASHTO 10 rad/sec. @ 250C Maximum 5,000 kPa T315 Creep Stiffness, S (Stiffness), @ 60 sec. @ -12OC Maximum 300 Mpa AASHTO T31 3 M-value, @ 60 sec. @ -12OC Minimum 0.300 . .., . II . ,., 916-1.3.5 Notification and Evaluation: In the event that a Specification Compliance test is outside specification requirements or a Quality Control test is outside limits established by the supplier as part of his Quality Control Program shipments of that product to Department projects will cease immediately and the Contractor and the State Materials Office will be notified and the product retested for Specification Compliance (resampling as appropriate). Where the retest for Specification Compliance meets all requirements, shipments of that product may resume. Where off-specification material has been shipped and the retest confirms the original test, the Contractor and State Materials Office will be informed of the steps taken to achieve specification compliance on the product shipped. Where off-specification materials has been shipped, further shipment of that product to Department projects shall remain suspended until the cause of the problem is evaluated and corrected by the supplier to the satisfaction of the State Materials Engineer. 916-1.3.6 Certification and Verification: The supplier shall furnish certification on the bill of lading for each shipment of PG binder delivered to a Department project that includes: the quantity, the Superpave PG asphalt binder grade (including QPL number), PG binder LOT, a statement that the binder is in conformance with 916-1 and the suppliers Quality Control Program, and the quantity of silicone and anti-strip agent addition as applicable, including product designation (QPL number as applicable). Any special handling or temperature requirements shall be indicated on the certification and are solely the responsibility of the Contractor to follow. The Department may sample and test PG binder from the suppliers storage tank, the delivery vehicle, and/or Contractors storage tank to verify and determine compliance with this and other specification requirements. Where these tests identify material outside specification requirements, the State Materials Engineer may require the supplier to cease shipment of that PG binder product. Further shipment of that PG binder product to Department projects may remain suspended until the cause of the problem is evaluated and corrected by the supplier as necessary to the satisfaction of the State Materials Engineer. . r-'I . ,.., . " . ,., . Pl . II . .., . rl . .., . -, . 916-2 Recycling Agents. 916-2.1 Requirements: The asphalt recycling agent (RA) shall be an asphalt cement (PG asphalt binder) or an asphalt cement blended (as necessary) with a softening agent or flux oil, and shall meet the following requirements: ..., . 1"1 . r-, . ..., 09/09 01000-166 03-4122.F .