Reso 2012-1962 - Laserfiche WebLink

Home Browse Search

BID #FY 29 -2 ."02 CITY OF HALLANDALE BEACH PAGE 8 OF35 SPECIFICATIONS THIS IS NOT AN ORDER Flying Cross Item: 34W7886Z MEWS SHIRT SPECIFICA' St.E= Fabric: Content: 100% Textured Polyester conforming to the following specifications: VII_,Lt ight: 7.5 ozJ Linear. yd. 67 warp X 49 filling yams per sq. inch Tear Warp 6.6 lbs. Filling 8.5 lbs. Tensile: Warp 159 lbs. Filling 155 lbs. Color: LMD an matching standard sample on display. Style: Plain front coat style, form fitting, collar attached, long sleeves with barrel cuffs. Two pleated breast pockets. Shoulder straps. Full badge reinforcement. Matching inside yoke and collar band of high lustre Poly -TWIN. Collar 8 Stand: Style and dimensions as sample on display. Collar points to measure 31/4" long with fused -in Mylar stays. Collar height at rear 11/2". Topstitched 114" off the edge. Collar stand to measure 15116" at rear. Collar and band to be die cut. Collar interlined with #250 Damon. Band interlined with "Crease N Tack ". Front: The left front shall have a top center 1 1/2" wide with two rows of stitches 7/8" apart. The shirt will have 7 buttons and buttonholes on the front; spacing between each will be 3 3/4" except the spacing between the neck button and the first button on the front, which will be 3 Y. ". Top center interlined with 0250 Dacron. The fronts shall be joined to the yoke so that both raw edges of the yoke are turned under, with the front sandwic i ed between, and then all throe are stitched down with a 1/16" raised stitch. Safety stitch joining unacceptable. A 15" nylon zipper, to be set below the second button and buttonhole shall accomplish front dosure. The top, second and bottom buttons to be attached to the right front, the balance to be sewn over the buttonholes on the left front. Shoulder Straps: Style and dimensions as sample. Asymmetrical shape topstitched 1/4" off the edge to be set on yoke with leading topstitches conforming with front joining seam. To measure 2" at sleeve tapering to 1 3/8" and set not more than 1/2" from folded collar. Cross - stitched approximately 2" from sleeve seam. Creased and edge stitched shoulder strap omwiniction unacceptable. Badge Two-ply sling 1" wide centered over left pocket and stitched to shoulder seam Reinforcement: and flap setting stitch. To have 2 buttonhole eyelets approximately 1 114" from top of pocket flap spaced 11/4" apart and centered on sling. Pockets: Two breast pockets with 1 1/2" stitched pleats and mitered comers. Pocket to measure 5 518" wide, 6" deep. Left breast pocket to have 1 1/2" pencil stitch. Each pocket to have Velcro tape 3/4" long by 1/2" wide positioned on both edges of pocket to correspond with outer scalloped flap points as sample.