Reso 2012-1962 - Laserfiche WebLink

Home Browse Search

BID #FY 2006- 2046 -002 CITY OF HALLANDALE BEACH PAGE 9 OF35 FLORIDA SPECIFICATIONS THIS 19 NOT AN ORDER Flaps: Deep scalloped design to measure 5 7/8" across and 2 314" In depth at canter point, 2114" at sides. Secured to shirtfront approximately 1/4" above pocket. Topstitched 1/4" off the edge. Left flap to have invisible penal opening 11/2" to correspond respond precisely with pence slot of pocket. Both flaps to be interlined with Dacron #250. Button sewn on top of flap buttonhole. Creased and edge stitched pocket flap construction unaoosptable. Under side of the flap to have Velcro tape 314" long by 1/2" wide, positioned on outer points of both pocket flaps as sample. Sleeves: Straight at width — no bias - of one place shaped at head, jacket type. Sleeve shall have a one piece round elbow reinforce I W d and Vent facing. Lower facing shall measure apprwdmately 1/2" wide. Cutts: To measure 3" in depth with rounded corners as sample. Topstitched 114" off the edge. With two buttons and corresponding buttonholes on each cuff and one button and buttonhole in center of facing. Both cuffs to be interlined with #250 Dacron. Buttons: First grade IWigne peadescent plastic to match. Sewing: Single needle throughout An topstitched 1/4" off the edge. Sleeve inserting and side dose felting safety stitched. Thread: AN sewing threads to be fast color polyester core polyester wrap to match Interlining: Collar, Cuffs, Pocket Flaps and Top Centsr to be interlined with Dacron 0250. Collar band to be Interlined with "CreawN- Tack". Ml tary 5 stitched -In sharp mNitary creases on all shirts. One crease on each front to Creases: be centered vertically. No creases through pockets or flaps. Spacing for military creases on shirt back to be proportionate to the size of the shirt as follows: sizes 14 through 15112 - creases to be 4 3/4" apart; sizes 16 through 18 inclusive - creases to be 5 318" apart as measured from the car crease. Construction: Collars and flaps are made by the conventional construction. Top ply, bottom ply and interlining are first stitched together, then turned rightside out and finally topstitched. Convertibility: This garment shall be designed to accommodate removable metal buttons having eyelets under the sewn buttons on the shoulders, pockets, cuffs and button front Protective pieces shall be sewn on the inside of the garment on the shoulders, cuffs and on the inside of the right front. Country of All raw materials and assembly thereof made in the U.S.A. Manufacture: