GEO-Surfaces - Laserfiche WebLink

Home Browse Search

1 3) The flanged edge of a GeoFlo roll must always butt with an un-flanged edge. Where two flanged edges meet due to slope transitions. such as at the crown of the field,one flange edge must be trimmed and removed to prevent a gap in the plane of the GeoFlo surface. 4) The GeoFlo will consist of a high density, cupsated core, covered with a needle punched non-woven geotextile on the top. 5) Total weight of blanket will be a minimum of 24 oz./sv and capable of accepting a compressive load of 20,000 psi, without crushing and while maintaining measurable flow. 6) The GeoFlo will have a core incorporating expansion joints every 4 feet. The shock pad and drainage blanket so constructed, must provide a complete underlayment, over the entire field area, when mechanically bound with mechanical tape: and must not wrinkle, wave. float,buckle or otherwise disturb the planarity of the artificial turf surface, even under the most elevated conditions for thermal expansion to be experienced at the site. 7) The thickness of the blanket will be a minimum of 0.5 inch. C. REPLICATED GRASS INSTALLATION: 1 I) The replicated grass will be installed along the length of the field and cover the full width as shown in the engineering drawings. The carpet rolls are to be installed directly over the properly prepared dynamic drainage blanket base. Extreme care should be taken to avoid disturbing the shock pad. The full width rolls shall be laid out across the field. Utilizing standard state-of-the-art bonding procedures, each roll shall be attached to the next. When all of the rolls of the playing surface have been installed. the sideline areas shall be installed at right angles to the playing field turf. Turf shall be attached,by industrial rustproof staples directly to wood nailer,around perimeter of field at maximum three-inch(3 inch) intervals. 2) The replicated grass rolls shall be installed so that tufted lines are placed as shown on manufacturer's drawing, which drawing shall be pre-approved by Purchaser prior to manufacture of replicated grass. The same drawing shall also show ' location of all optional in situ permanent lines or markings. 3) Immediately after brushing with a motorized rotary nylon broom, the blended infill material shall be spread evenly by using a drop or broadcast spreader(minimum 5 foot wide), in multiple applications, each no more than 15% of the total application, at a uniform rate. Between applications, and just prior and subsequent to infilling the area shall be brushed with the motorized broom. Infill depth will be I inch (1.0°+/- 0.1'), infill material to be uniformly incorporated into the replicated grass system. PROJECT CLOSEOUT/WARRANTY: Upon final acceptance or first use of the finished sports field (whichever occurs ' first)the Geo-Surfaces Warranty becomes effective,which warranty shall be the only warranty obligation by Geo-Surfaces to the Owner. 1 1 1 1 1 Global Synthetics Environmental.LLC • 6326 Highland Road • Baton Rouge.LA 70808 • 225.907.4763• www.Qeosurfaces.com 9 #12-10-03 1