Gateway Park Technical Specs Volume 1 (3)

Home Browse Search

Gateway Park Center PERKINS+WILL 810495.00 12/06/18 033000-9 Cast-In-Place Concrete shown in the shop drawing may proceed, provided that work is in compliance with the notations shown on the shop drawings and the Contract Documents. Promptly resubmit the corrected document for record. c)REJECTED indicates that the SER requires resubmission of the submittal after correction per notes and comments. None of the elements of work shown on the shop drawing shall be fabricated, manufactured or constructed. Contractor to revise and resubmit until SER response of No Exceptions or Exceptions Noted is received. D.Substitution Request 1.Requests for any departure from Contract Documents must be submitted in writing by the Contractor and accepted in writing by the Design Professionals, prior to receipt of submittals. 2.All substitutions must be requested using the structural substitution request form included at the end of this section. Acceptance using the structural substitution request form indicates acceptability of the structural concept only. Contractor must submit shop drawings reflecting accepted substitutions for review in accordance with this Specification. The structural substitution request form, even if accepted, does not constitute a change order. 3.Accepted substitutions or modifications shall be coordinated and incorporated in the work at the sole expense of the Contractor. 4.The acceptance by the Design Professionals of a specific and isolated request by the Contractor to deviate from these requirements does not constitute a waiving of that requirement for other elements of, or locations in the project, unless specifically addressed as such and permitted by the Design Professionals in writing. 5.Compensation for Additional Services: Should additional work by Design Professionals such as design, documentation, meetings and/or site visits be required which are necessitated for the review and/or incorporation of the Contractor-requested substitution, including indirect effects on other portions of the work, the Contractor is responsible for paying for additional work performed by the Design Professionals at the standard billing rates plus out-of-pocket expenses incurred at cost + 10%. Additional costs for testing and inspection by the Owner shall also be compensated by the Contractor. 6.Contractor is responsible for means and methods and any impacts on other portions of the work that may arise from this substitution. E.Request for Information (RFI) 1.RFIs shall be submitted by the Contractor. RFIs submitted by other entities will be returned with no response. 2.Limit RFI to one subject. 3.Submit RFI immediately upon discovery of the need for interpretation or clarification of the Contract Documents. Submit RFI within timeframe so as not to delay the Construction Schedule while allowing the full response time described below.