Reso 2008-1273 - Laserfiche WebLink

Home Browse Search

I I I I I I I I I I I hard"ware, and will only be accessible to people who have the proper authority to enter, and then as an exit, a discharge for the building. This is the largest hid of glassware in this project. 6. On one side it says tempered glass, and on the other side it says impact glass. Sheet Al03: !;i-inch tempered glass, it has to be largc and small missile impact rated, as every assembly of storefront v~lJ.iety needs to have a Notice of Acceptance, and the Building Code requires impact rating. The assemblies that are chosen al.c going to have that NOA and they will be tcsted for impact rating, however, thc glass is tempered glass. Another area that has glass is in Sheet Al04, Detail #1 and #5: thc existing guragc has transitions from the garage into thc main building of the officcs, there is an opening on the north side of the elevators where there is rain coming in and causing problems with ponding of water. We arc putting in fixed glass windows and again, they have to match the existing building. 7. Will wind pressure be specified in Sheet Al 03? We will provide you with the wind pressures. I I I I I I I I The only other area related to glass is in Sheet Al 04, Dctail #2 (Floor Plan) and #6 (Elevation/Section): There is an existing door leading into the entrance of the Commission Chambers, but there is no antechambcr, no separation from existing exterior door into the space, and so once you open that door, the noise comes inside of the chambers. Inside of the existing doors, we are adding a small antechamber with some interior doors, and doors in the drawings do not have any hardware, any locking devices, they are only there for noise purposes. In order to create that antechamber, we need to add a wall and enclosing it with another wall that has thc door, and the existing scaling to the area is going to remain. There is an existing ceiling there that is 9-feet high. Sheet AWl: The biggest job of this project is a ncw roof structurc. Then is an existing roof which is all pre-C~lst and it circlcs around the building, but it ends in a particular spot just where the Post Officc is. We are extending this roof so that people walking along this exterior galleria, can walk into the garage building without getting wet. In onlcl. to complete that roof, we an adding a couple of columns, there is somc demolition w01"k involved, it is all reinforced concrete, there is lightweight framing underneath the concrcte to creatc a false ceiling, there is sprinklcr work to be done in this situation. Below that new roof is where we are going to be adding that new bench that we spoke about at the beginning of the meeting. Sheet Al 02, Detail #8, #4, and #1: The garage building has 3 Yz noors, and the 3nl floor is the connection to existing elcvators. Those existing elevator doors are open to thc elcments, wc are going to be adding a new aluminum structure to give weather protection to those elevator doors. Additionally, in that area there is going to he some light dcmolition wo.-l( to add a new exterior door to the interior building. This huilding Bid 08-05-02 Pre-Bid Conference QA Page 2 of 5